How can we solve the problem of Rubber Internal Mixer failure? Let's use engineers to teach you how to solve some common faults in banburying. Question 1: When the contact surface between the fixed ring and the moving ring of the internal mixer is uneven, and the sealing oil film cannot be formed, how should we deal with it? Treatment method: disassemble the Internal Mixer and check the fixed ring. If the drag contact surface is not damaged, but the contact rate is low, it needs to be run-in. The run-in time is more than 4-8h. Question 2: There are hard particles between the moving ring and the fixed ring of the banburying, which will damage the contact surface and prevent the contact surface from forming a sealing oil film. What should we do at this time?
Treatment method: If the moving coil is strained, it needs to be repaired by grinding with oilstone, and a special device is required for grinding. The fixed ring is a two-half structure, which can be disassembled for grinding. After the planes of the moving coil and the fixed coil are ground, assemble the fixed coil and grind for several hours at a slow speed, lubricating oil during grinding.
Question 3: Sometimes the alloy of the internal mixing motor ring will fall off inadvertently Solution: Replace the moving coil, then set it, and run the moving coil for several hours. In fact, the quality of our internal mixer is very good. As long as we pay attention to daily maintenance, keep clean and the presence of industrial lubricants, and pay attention to the use, there will be few failures. We also have Dispersion Kneader on sale, if you are interested in this, you can contact us. We are a professional manufacturer of Extrusion Pelletizer, with many years of experience and mature technology, and a large inventory, welcome to visit our website.