How Can The Open Mixer Be Safe
2023-02-11
The safety failure of the Rubber Open Mill has always been a major issue that has troubled people. Many mill manufacturers have also made many adjustments to this, but the market still often hears that the master of a certain company`s mill was opened. The roll of the mill was rolled in, and the master of a company's mill died because of a mistake in operating the mill... etc. It can be seen that the safety of the mill is the biggest hidden danger of the mill, and there is no one. Unlike Extrusion Pelletizer, it is easy to operate. The open mixer is also called the open rubber mixer. Because the rubber is mixed in an open way and the rubber needs to be manually turned over, the operator of the open mixer consumes a lot of energy. Therefore, it is very difficult to recruit an operator of the open mixer in the market. reason. Lina Industry has made the following policy on how to make the mill safe. You can refer to it: 1. Before operating the mill, first check whether the mill is stable, and then start the mill to make rubber after making sure that there is no other problem with the mill. 2. The master who operates the mill is forbidden to wear strange clothes. When operating the mill, the sleeves should be rolled up to prevent the sleeves from being involved in the mill and causing people to be involved in the mill. 3. The operation time should not exceed 10 hours. Since the physical strength required to operate the open mill is very large, the operation time needs to be appropriately reduced. 4. The master who operates the mill is forbidden to drink alcohol and doze off 5. Choose a mill with high safety performance. Here I recommend Lena`s mill. There is no other reason. The safety performance of Lena`s mill is far higher than that of ordinary mills. At present, it is the most popular in our industry. The way to do it is to have an emergency stop switch on the left and right sides, but in fact it is just for decoration. Imagine waiting for us to find that our hands are about to be caught by the rollers of the mill, and there is still time to press the switch? It must be too late. So this is the biggest difference between us and other companies, that is, we pay great attention to the factor of safety when designing the mill. You think, if a piece of equipment has serious safety hazards, even if the price is very cheap, if something happens, you will lose more than you gain, right? At the beginning, Lina used infrared to sense the mill, but later found that it was not feasible, because the temperature of the rubber material was constantly changing, and misjudgments were prone to occur. Later, the circuit and switch were installed at the knee position. When the danger is felt, as long as the knee is pushed forward, the open mill will immediately perform two actions, one is to stop immediately, and then reverse immediately. This is our patent. Now maybe our colleagues can imitate these functions of ours, but they can't imitate the essence. The essence is whether the roller stops immediately and then reverses immediately? Just like we drive, it is difficult to stop the car immediately. It takes a few seconds to stop the car, which is the crux of the problem. 6. Improve the safety awareness of mill operators, give training before taking up the job, and then take up the job after passing the qualification. In short, the operation of the mill mainly depends on the person who operates the mill, and it is very important to formulate a series of safety operating procedures. We have Rubber Internal Mixer on sale, if you are interested, you can consult us. 
